不銹鋼管超聲波探傷儀是一種比較精密的電子儀器，為減少故障的發生，延長其使用壽命，使其保持良好的工作狀態，應注意對其進行維護。亞洲歐美色綜合一區二區在線:不銹鋼管超聲波探傷儀的維護應注意以下幾點：


1. 在使用前，應仔細閱讀使用說明書，了解其性能特點，熟悉各控制開關和旋鈕的位置、操作方法和注意事項，嚴格按說明書要求操作。


2. 搬動超聲波探傷儀時應防止強烈振動，現場檢測尤其在高空作業時，應采取可靠的保護措施，防止摔碰，盡量避免在靠近強磁場、灰塵多、電源波動大、有強烈振動及溫度過高或過低的場合使用超聲波探傷儀。


3. 不銹鋼管超聲波探傷儀工作時應防止雨、雪、水、機油等進入超聲波探傷儀內部，以免損壞電路和元器件。


4. 嚴格按說明書進行充電操作。放電后的蓄電池應及時充電。對于存放較久的蓄電池，在連接交流電源前，應仔細核對超聲波探傷儀額定電源電壓，防止錯接電源，燒毀元器件。對于使用蓄電池供電的超聲波探傷儀，也應定期給蓄電池充電，否則會影響蓄電池容量，甚至使其無法重新充電。


5. 旋轉或按旋鈕時不宜用力過猛，尤其當旋鈕在極端位置時更應注意，否則會使旋鈕錯位甚至損壞。接電源插頭或探頭插頭時，應用手抓住插頭殼體，不要抓住電纜線。應將探頭線和電源線理順，不要使其彎折扭曲。


6. 每次用完不銹鋼管超聲波探傷儀后，應及時擦去表面灰塵、油污，放置在干燥的地方。在氣候潮濕地區或潮濕季節，超聲波探傷儀長期不用時，應定期接通電源開機一次，開機時間約0.5h,以驅除潮氣，防止超聲波探傷儀內部短路或擊穿。


7. 當不銹鋼管超聲波探傷儀出現故障時，應立即關閉電源，及時請維修人員檢查修理。切忌隨意拆卸，以免故障擴大和發生事故。